Sturdy steel front sights for the 1911. Requires fitting and installation by a qualified gunsmith installation.
Generally, all installations will require machining. Exception will be if the firearm already has Novak sights. However, if
installing Extreme Duty sights, some machining may be required even if changing from other Novak sights. Some Kimber,
Springfield and H&K pistols have been factory-equipped with Novak sights.
Complete instructions are included with these sights if they require machining for installation.
Novak front sights are dovetail. Slide will require milling if not already set up for dovetail front sights. If changing from
dual crimp front sights, the holes in the slide will have to be filled or they will show after machining for Novak front.
Extreme Duty sights, comments from Novak:
1911 Colt 70 and 80 series. Will require full milling if handgun does not have Novak sights. If handgun does have
sights, will still require a small milling cut in front of the existing rear dovetail for the sight's hinge system. Front blade
recommended is .225" height.
Springfield. Same requirements as Colt, above.
Kimber. Milling is not required if handgun has Novak sights. Front blade recommended is .175" height.
Smith & Wesson. Same requirement as Kimber, except front blade recommended is .305" height.
Browning. Will require full milling of slide at front and rear. Front blade recommended is .215" height.
Gunsmith installation is recommended
* Novak-style dovetail cut depth varies depending on the brand of sight and model chosen.
Note: Other front sight dovetail cuts and dimensions may exist. The ones listed here are applicable to the sights
sold by MidwayUSA.