XS Lever Scout Scope Base Weaver-Style Winchester 94 Angle Eject Matte

Product #: 467501 XS Sight Systems #: 28-2196A-095-1 UPC #: 647533023207
$49.50

Please Sign In to use this feature.

Product Information

This Weaver-style base is machined from lightweight aluminum and allows a scope or red dot sight to be mounted in the forward, scout rifle position. For use with rifles that have a rear dovetail located approximately 4" from receiver. Non-angle eject rifles will require drilling and tapping. Black anodized finish. Please note: This mount is attached to the rifle with hard epoxy and installation requires significant gunsmithing. Once installed, the base becomes a permanent fixture and cannot be removed. For more detailed information, please consult the "Technical Specifications & Use" link below.

Technical Information

Material: Anodized aluminum

Finish: Black

Features: Allows forward mounting of scout scopes or red dot sights.

Gunsmithing Required: Yes, see installation procedure

Notes:
  • For rifles with rear dovetail located approximately 4" from receiver.
  • Non-angle eject rifles will require drilling and tapping.

    Installation Procedure:
  • Installation requires removal of magazine tube and forend
  • Pillar hole in mount will need to be opened up with a round file
  • Drift front jackscrew to align mount with centerline of bore
  • Clean and degrease barrel, receiver and mount
  • Apply Vaseline® to the mounting screw holes to prevent epoxy from entering holes
  • Mix the resin and hardener of the supplied Marine-Tex™ epoxy according to the instructions
  • Epoxy color is gray
  • Apply mixed epoxy in a thick ribbon along the center portion of the underside of the mount
  • Place mount on rifle and snug screws to hold mount in place while the epoxy cures
  • Recheck alignment and adjust as needed
  • Use alcohol to clean off excess epoxy
  • After allowing epoxy to cure for 24 hours, tighten all attaching screws and re-install forend and magazine tube
  • This procedure, once accomplished, is not reversible. The mount becomes a permanent fixture once the epoxy cures

    • Was this information helpful? Yes No

    This Information was not helpful because:

    Know someone who may like this? Email this Page to a Friend

    Customer Reviews

    The statements and opinions expressed within Customer Reviews reflect each author's personal perspective and do not imply endorsement by MidwayUSA, its Employees or any other organization. Customers should in no way infer that MidwayUSA has validated review information as safe, accurate or appropriate.

    NOTE: Prices, specifications and availability are subject to change without notice.
    We reserve the right to correct typographic, photographic and/or descriptive errors.
    Navigation
    Recently Added
    Suggested Products