Featuring a HI-SPEED hammer with 50% lock time reduction over standard hammers, this two stage trigger is adjustable for overtravel and sear engagement. 1st stage pull weights range from 1.3-3.5 lbs, 2nd stage pull weights range from .5-1.5 lbs. Includes instructions. Minor fitting may be required. Will not fit HK 416/417. Steel.
Trigger is adjustable for overtravel and sear engagement
50% lock time reduction over standard hammer
Gunsmithing is recommended by the manufacturer, safety clearance is the only known fitting required less than 5% of the time
Will not fit HK416/417
Pull Weights: 1st stage 1.3-3 lb and 2nd stage 0.5-1.5 lb
A note on trigger and hammer pins:
Our good friends in Hartford have made one more deviation from the norm in some of their AR type rifles, using an approximately .170" (large) hole for the hammer and trigger pins as opposed to the .154" (small)diameter pins of the rest of the world, including all military M16s. This change was made in order to make it more difficult for civilians to use M16 parts in AR rifles. This is important to note, and before purchasing any hammer, trigger, disconnector or lower parts kit you need to check the diameter of the holes in your lower to determine if you have a "large" or "small" pin lower receiver.