Double-Alpha Race Master Locking Block Assembly S&W M&P Black
- Apex Tactical Forward Set Sear and Trigger Kit S&W M&P... $164.95 Available
- Apex Tactical Reset Assist Mechanism (RAM) S&W M&P Steel... $23.95 Available
- Apex Tactical Duty/Carry Action Enhancement Kit (AEK) S&W M&P... $92.95 Available
- Apex Tactical Action Enhancement Kit (AEK) Trigger S&W M&P... $76.95 Available
- Taylor Freelance Extended Magazine Base Pad Smith & Wesson M&P... $39.99 Available
The Double Alpha Race Master Holster utilizes an efficient and easy system to allow shooters to switch their holster from one gun type to another by means of changing the Insert Block Assembly. This switch is fast and easy and can be done in under 2 minutes, and without losing any of the holster's adjustments or settings.
To remove the Insert Block Assembly, first unscrew completely the Tension Adjustment Screw and remove it from the holster. It extracts with the Tension Spring on it. Then, using the supplied 2.5 mm key, remove the two Insert Assembly Screws. Now you can slide the Insert Block Assembly forward and out of the Holster Body. It may be a tight fit, so some wiggling may be required. When using a second insert, you will need to use your original Tension Adjustment Screw, Tension Spring, and Pressure Plate. Take care not to lose these small parts in the assembly process. Position the Pressure Plate as shown in the picture. This part is directional, so make sure that the round indent (dimple) is above the center hole and facing outwards. Hold the assembly horizontal (so the Pressure Plate does not slide out of position) and push the new Insert Block Assembly into the Holster Body. Use the tip of a hex key to ensure the Pressure Plate is aligned correctly so that the Tension Adjustment Screw is inserted through its center hole, allowing the spring to press on top of it. Tighten the Tension Adjustment Screw until it catches in the nut inserted on the opposite side of the Insert Block Assembly. Replace and tighten the two Insert Assembly Screws to lock the new insert into place. Using the External Activation Lever, slide the Insert Slide Lock up and down a few times to ensure it is moving as it should. In the down position, you should be able to engage the Safety Lever.
- Locking block
- Sliding lock
- Safety lever
Shipping Weight: 0.500 PoundsXThe total weight of the product, including the product’s packaging as it sits on our shelf. Since some products ship directly from the Manufacturer, their weight may be unavailable. Because of variations in the manufacturing process, similar products may have differing weights. Unless the product is designated as “Ships Alone”, Shipping Weight does not include the shipping box or packing materials associated with your order.
XProduct ships from MidwayUSA, separate from any other products on your order due to its size. Products that are Shipped Alone incur separate "Per Order" and "Per Pound" shipping charges.
XProduct is regulated by the US Department of Transportation (DOT) and cannot be shipped via USPS or air shipping methods. DOT-Regulated products must ship UPS Ground.
XProduct is restricted by shipping carriers and cannot be shipped to certain locations or via certain shipping methods.
XAdditional shipping charge for HazMat products. Carriers charge extra to ship packages with products they consider hazardous, such as reloading powder and primers.