Lee Pro 1000 Progressive Press Z-Bar to Adapt Case Feeders to 40 S&W, 45 ACP, 45 Auto Rim

Product #: 138039
| Manufacturer #: TR2452B
Status: Available
   Should Ship Today
Quantity

It never hurts to have extra parts on hand if something breaks. Be prepared for any breakage with these quality factory replacement parts for Lee presses. Each part is made to the same specification and dimensions as the parts used in the original assembly.

Technical Information

Notes:

  • Required to convert Lee Pro 1000 to 45 ACP.
  • Will work with both large and small case feeders.
  • Effective 10/10/00 Lee has informed us that the Pro 1000 requires the Bent Z Bar for not just the 45 ACP, but also the 40 S&W, the 45 HP Italian and the 45 Auto Rim. They did NOT say it is needed for the 10mm Auto, despite it's similarity to the 40 S&W. The Lee representative said an alternative to purchasing a pre-bent bar would be to just bend the existing bar 1/8 inch to clear the case loading mechanism.

    • Application Charts & Information

    Overall Rating:
    5 out of 5
    Used this Product?Rate It
    5 stars
    Jeffrey Knoll of San Diego, CA
    Date posted: 2/2/2002
    Seems to do the trick!
    Was this review helpful?
    Yes |
    4 found it helpful |
    6 did not
    Have a question? Visit GunTec Dictionary Need a gunsmith? Visit Gunsmith Locator
    NOTE: Prices, specifications and availability are subject to change without notice.
    We reserve the right to correct typographic, photographic and/or descriptive errors.
    WEBSRVR5