Winchester Brass 338 Winchester Magnum

Product Family #: 1390498126
Status:
Select
From options above
$34.99 - $556.99

Each and every piece of Winchester brass is made to meet and exceed the most demanding quality control and performance standards in the industry. New, unprimed brass. This is not loaded ammunition.

Preparation:

  • Due to the manufacturing process and/or shipping, case mouths may not be perfectly round. To ensure a round case mouth, cases must be sized (or have the expander ball of the sizing die run through case neck) and deburred/Chamfered prior to loading.

    Note:
  • A light "staining" may be found on the case neck of new brass. This is due to annealing. Annealing is a process, performed by the manufacturer, which involves rapid heating to a specified temperature followed by rapid cooling. This process imparts cases with the proper hardness to securely hold a bullet as well as gives flexibility to expand and contract upon firing and repeated forming. The "staining" is a residue from this process. This stain may be removed by tumbling before loading. Brass should be full-length sized, trimmed and chamfered before loading.

    • Application Charts & Information

    Overall Rating: 4.5 stars
    Used this Product?Rate It
    5 stars
    CHRIS B. of GOULDSBORO, PA
    Date posted: 7/3/2009
    I bought this brass and would again without question. Extremely consistent, clean, and ready to use. I'd recommend this brass to everyone and will buy again.
    Was this review helpful?
    Yes |
    9 found it helpful |
    0 did not
    4 stars
    R. B. of Fresno, CA
    Date posted: 5/17/2010
    As with most brass bought in a bag, the case mouths need re-sizing. Out of 100 I had one mouth whose 'dent' had actually produced a slight cut about 1/32 of an inch into the neck. With careful excavation of the crushed brass on the inside of the mouth that case was salvaged for a fouling round. If you know what you are doing this is excellent brass at a good price. If you are learning to handload, I would recommend the Nosler brass in order to guarantee better consistency while learning the ins and outs of primer pockets, neck thickness, consistency in weight, etc.
    Was this review helpful?
    Yes |
    0 found it helpful |
    0 did not
    Have a question? Visit GunTec Dictionary Need a gunsmith? Visit Gunsmith Locator
    NOTE: Prices, specifications and availability are subject to change without notice.
    We reserve the right to correct typographic, photographic and/or descriptive errors.
    WEBSRVR4