Buffalo Bore loads their ammunition up to maximum SAAMI specifications, which delivers devastating performance on a wide range of game. Please note that this ammunition is not intended for older guns. It is made for modern firearms only, as some of the ammunition could damage older and weaker firearms. This ammunition is new production, non-corrosive, in boxer primed, reloadable brass cases.
Owner of Buffalo Bore Tim Sundles on 10mm Lead Free Ammunition:
This is a full power 10MM load that is within SAAMI spec and is thus safe for use in ANY/ALL 10mm pistols. Loading this long-for-weight all copper bullet in the 10MM case, causes powder capacity limitations that we do not experience with shorter/heavier lead alloy bullets and thus our advertised 1500 fps velocity cannot be reached, regardless of how may internal ballistics charts tell us that we should be able to launch a 155gr. bullet @ 1500 fps from a 5 inch barrel, that long light weight bullet simply uses too much of the available case capacity to do so. See our below real world velocities fired from real world pistols, not extra long laboratory barrels, that give false high velocity readings. With Buffalo Bore ammo, you'll achieve the velocity reading we advertise in the real world where it matters when your life and the lives of your loved ones may hang in the balance.
If you are firing this 10MM ammo from an auto loader and are experiencing high extreme velocity spreads, it is not the ammo. Full power 10MM ammunition has always generated enough pressure to require a pretty stiff recoil spring in your handgun this of course depends on many variables like your particular slide weight, etc. When the cartridge fires, it generates enough pressure/recoil to prematurely open your breech face in some guns. When this happens, the opening breech has an effect on the burn rate of the powder. This can result in some fairly high extreme velocity spreads. If you are experiencing extreme velocity spreads (in excess of 50 fps) simply install a stiffer recoil spring. For example, I have an original Colt Delta Elite. This Colt, with the factory spring runs extreme spreads of about 35 fps, with this load. I am happy with an ES of 35 fps, so I leave the Delta spring alone. My custom built Para Ordinance 1911, with a Nowlin barrel, runs extreme spreads of about 70 fps, so I installed a recoil spring that was roughly 4 lbs heavier and the extreme spread dropped to about 35 fps. My Glock mod 20 was running extreme spreads of nearly 100 fps, so I installed a 6 lb heavier recoil spring and brought the ES down to 50 fps. The folks at Wolff will tell you what the factory spring rating is for your particular pistol, so you'll know where to start. I should note, these high ES #'s really don't matter in the real world as they do not affect accuracy or reliability. The firearms industry fixed this ES problem by watering down 10MM ammo, to the point that most 10MM ammo made by major manufacturers is pretty weak, but it does not open your breech face early... If weak ammo is the fix you want, most any 10MM ammo made by major manufacturers will do. If you wish to shoot our full power 10MM ammo, you can choose to live with the high ES (you'll only know if you are getting high ES #'s if you use a chronograph) or you can install a stiffer recoil spring.