XS Lever Scout Scope Base Picatinny-Style Winchester 94 Angle Eject Matte

  • Product #: 467501
  • Manufacturer #: WI-6000R-N
  • UPC #: 647533042512
XS Lever Scout Scope Base Picatinny-Style Winchester 94 Angle Eject Matte
  1. {{::image.alternatText}}
List price was $96.99 our price $67.50 4 at this price
SHIPS FREE
  • {{fee.amount}} {{fee.description}}
Only 4 in stock - order soon!
Ships tomorrow from MidwayUSA
Finish: Matte Black
Material: Aluminum
Style: Picatinny
Piece: 1

Product Overview

This Picatinny-style base is machined from lightweight aluminum and allows a scope or red dot sight to be mounted in the forward, scout rifle position. For use with rifles that have a rear dovetail located approximately 4" from receiver. Non-angle eject rifles will require drilling and tapping. Black anodized finish. Please note: This mount is attached to the rifle with hard epoxy and installation requires significant gunsmithing. Once installed, the base becomes a permanent fixture and cannot be removed. For more detailed information, please consult the "Technical Specifications & Use" link below.

Notes:

  • Allows forward mounting of scout scopes or red dot sights.
  • For rifles with rear dovetail located approximately 4" from receiver.
  • Non-angle eject rifles will require drilling and tapping.

 

Installation Procedure:

  • Installation requires removal of magazine tube and forend
  • Pillar hole in mount will need to be opened up with a round file
  • Drift front jackscrew to align mount with centerline of bore
  • Clean and degrease barrel, receiver and mount
  • Apply Vaseline® to the mounting screw holes to prevent epoxy from entering holes
  • Mix the resin and hardener of the supplied Marine-Tex™ epoxy according to the instructions
  • Epoxy color is gray
  • Apply mixed epoxy in a thick ribbon along the center portion of the underside of the mount
  • Place mount on rifle and snug screws to hold mount in place while the epoxy cures
  • Recheck alignment and adjust as needed
  • Use alcohol to clean off excess epoxy
  • After allowing epoxy to cure for 24 hours, tighten all attaching screws and re-install forend and magazine tube
  • This procedure, once accomplished, is not reversible. The mount becomes a permanent fixture once the epoxy cures

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.

Specifications

Was the information on this page helpful?

Community Q&A

Need More Information?

Customer Q&A are not compatible with your browser.

Update Your Browser Now!

Customer Reviews

Own this product?

Product Reviews are not compatible with your browser.

Update Your Browser Now!
NOTE: Prices, specifications and availability are subject to change without notice. We reserve the right to correct typographic, photographic and/or descriptive errors.