The TAB Gear SASR Suppressor Cover protects you, your can, and your equipment. Designed to prevent mirage from obscuring your site picture after multiple shots. Eliminating mirage is accomplished by the use of insulating materials - your can heats up, but the SASR stays cool. The outer shell of the TAB SASR will not heat up as much so your equipment and person will not become damaged with accidental or intentional contact. Removal and handling of your can, while inside the TAB SASR, immediately after firing is possible due to the high quality insulating materials used in the construction.
- Nomex thread and 1000 Denier Cordura Outer Shell
- Inner shell can withstand 1800 degrees Fahrenheit
- SASR Cover can slide back forth
- Multi-directional Installation
- Quick Release Mechanism
WARNING! Since the SASR cover has no built in recoil ridge at the rear to prevent the cover from sliding forward under recoil the user MUST engage the bungee, to prevent the cover from sliding forward under recoil and being shot down range. The retention method works very well and there really should be no valid reason for either model to be shot down range. Tighten the retention device down like you would your shoe laces, from front to back, and shoot a few rounds while observing the reaction of the cover. If it's moving slightly, tighten it down a little more. if it's not moving, loosen it slightly until you do see it start to move then tighten it back a bit. That will tell you how tight you need to have the cover.
These products are not recommended for long strings or rapid fire use with a .223/5.56 caliber rifle!